Hedge and tree work for the garden village.5% off for pensioners07763 100 477 · hello@ayleshamhedges.co.uk
Aylesham Hedges & Tree ServicesAylesham · Snowdown · Nonington

← All guides · Conifer hedges · October 2026

When and how do you trim a Lawson cypress hedge in Aylesham?

Lawson cypress is one of the most common formal hedging conifers in Aylesham's garden-village plots, but it has a strict rule that catches a lot of people out: cut into old brown wood and the bare patch will stay bare permanently.

Short answer

Trim twice a year: once in late April to early May and once in late August. Keep every cut within the green foliage. Lawson cypress does not regrow from bare brown stems, so any cut that goes past the green will leave a permanent gap. Taper the hedge wider at the base than the top so light reaches the lower growth, and trim regularly before it gets out of hand, because reducing an overgrown Lawson cypress hedge is much harder than keeping a well-maintained one in shape.

How Lawson cypress differs from yew and leylandii

Lawson cypress (Chamaecyparis lawsoniana) falls into the same broad category as leylandii: a fast-growing conifer that does not regrow from old wood. This puts it in a different category from yew, which is the one conifer that reliably breaks dormant buds from bare, brown stems. With Lawson cypress, as with leylandii, every cut must stay within the live green growth. Cut past the last green shoot on a stem and there is nothing below it to generate new growth, so the bare section stays bare.

Where it differs from leylandii is in its growth rate: Lawson cypress is somewhat slower-growing, which means it needs fewer cuts per year and does not escalate as quickly when left untrimmed. The 'Green Hedger' cultivar common in UK domestic gardens grows at roughly 30 to 60 cm per year when established, compared to leylandii at up to 90 cm. That slower pace makes it easier to maintain but does not change the fundamental rule about old wood.

When to trim: the two main windows

The first trim in late April to early May catches the spring flush of new growth while it is still soft and easy to cut cleanly with a hedge trimmer. At this point in the season the new shoots are extending but have not yet hardened, so the blades move through them smoothly. Trimming now also sets the shape early in the season before the summer growth extends further.

The second trim in late August is the more important of the two for keeping the hedge tidy over winter. Growth slows significantly from September onward, so an August cut holds the shape until the following spring with minimal further extension. Cutting later than early September is possible but risks leaving soft new growth that will not harden fully before the first frosts: frosted new growth browns back and can look ragged through winter.

Fast-growing cultivars or vigorous young hedges can benefit from a third, lighter trim in June or early July if growth has extended significantly between the spring and late-summer cuts. For most established hedges on Aylesham's chalk, two trims are enough.

The nesting-season overlap

The late-April to May trim window falls inside the main nesting season, which runs from 1 March to 31 August under section 1 of the Wildlife and Countryside Act 1981. Lawson cypress provides dense, evergreen cover that birds use readily for nesting. Before carrying out the spring trim, check visually from outside the hedge for adult birds entering or leaving repeatedly, audible chick sounds, or a visible nest structure. If you find an active nest, leave that section and return once the young have fledged. The August trim, from around the last week of August onward, falls at the tail end of the season but the main flush of breeding activity has usually passed for most species.

Shape: why the taper matters

The most common long-term problem with Lawson cypress hedges is die-back at the base: the lower foliage gradually thins and browns while the upper part of the hedge stays green. The cause is almost always the same: the top of the hedge is wider than the base, so it shades out the lower growth. On a conifer that will not regrow from old wood, this eventually becomes permanent.

The fix, and the prevention, is to trim so that the base is always slightly wider than the top. The RHS recommendation for this species is an inverted-wedge or A-profile: the hedge gradually narrows from the base upward, or at least runs with parallel vertical sides rather than flaring outward at the top. Even a modest taper is enough to keep light reaching the lower foliage. On a tall hedge, a slight chamfer on the sides is enough.

If you are starting from a hedge that has already widened at the top, the correction is gradual: at each trim, take slightly more off the upper sides than the lower, working the profile back toward a taper over two or three seasons rather than trying to correct it in one cut.

Height reduction

Reducing the height of an established Lawson cypress hedge is straightforward compared to reducing the sides, because the leader tips are green and trimming them back into green growth is the whole point. The RHS guidance, applied to Lawson cypress as to closely related species, is that healthy established plants usually respond well to a reduction of up to one-third of their height in a single season. Cutting more than a third in one go stresses the plant significantly and can cause dieback or permanent browning of cut surfaces in some cultivars.

If a hedge has grown substantially taller than desired, spread the reduction over two seasons: take no more than a third in the first year, let the hedge recover and produce new growth at the cut line, then reduce further in the following year if needed.

What to do with an overgrown Lawson cypress hedge

If the hedge has been left untrimmed for several years and grown much wider than its original shape, the options are limited by the no-old-wood rule. The top can be reduced in stages as described above. The sides are harder: if the hedge has extended beyond the line where green foliage exists, cutting back to the original line will cut into brown wood and leave bare patches. In this situation, the realistic choices are either to accept a wider hedge and trim regularly from the new, wider line, or to remove and replace the hedge entirely if it has expanded beyond what is workable.

This is why the most useful thing you can do with a Lawson cypress hedge is not let it get out of shape in the first place. A hedge that is trimmed twice a year and kept to a consistent width can be maintained almost indefinitely. A hedge that has been neglected for a decade is much harder to restore.

Nesting season and the spring trim

The April to May trim window falls inside the nesting season under section 1 of the Wildlife and Countryside Act 1981. Lawson cypress provides dense cover that birds use readily. Check the hedge visually for an active nest before starting work. If you find one, leave that section until the nest is no longer in use. See the nesting-season timing guide for full detail on what the law says and how to check.

Lawson cypress on Aylesham's chalk soil

Lawson cypress is tolerant of a range of soils but performs best on ground that is moist and reasonably well drained with a slightly acidic to neutral pH. Aylesham's chalk soil, typically at pH 7.5 to 8.0, is on the alkaline side of what the species prefers. On established chalk plots where topsoil depth is reasonable, most Lawson cypress hedges do fine: the species is adaptable, and many of the Lawson cypress hedges on Aylesham's 1926 garden-village plots have been growing there for decades without obvious problems. On very thin chalk with minimal topsoil, the hedge may grow somewhat more slowly and show pale foliage during dry spells.

For a newly planted Lawson cypress hedge on chalk, water thoroughly during the first two or three summers to help the roots establish before they reach the depth where moisture is more readily available. After that, most established Lawson cypress hedges on Aylesham chalk manage without irrigation in a normal summer.

Lawson cypress is one of the more susceptible species to Phytophthora root rot, a soil-borne water mould that affects the roots and causes sudden browning. On Aylesham's fast-draining chalk this is a lower risk than on a wet, poorly-drained site, but it is worth keeping the base of the hedge clear of standing water if you can. If a section of hedge browns rapidly without obvious physical cause, roots are worth inspecting before assuming trimming damage.

Tool care and clippings

A cordless or electric hedge trimmer works well on Lawson cypress. The foliage is fine-textured and cuts cleanly. Wipe the blades before you start and before moving to a different hedge: Phytophthora and other pathogens can transfer on contaminated tools, and cleaning takes a few minutes. Collect or blow clippings away from the base of the hedge after finishing rather than letting them build up against the stems, where wet material over winter can encourage fungal problems.

Want a quote for Lawson cypress hedge trimming in Aylesham?

I work across Aylesham, Snowdown and the surrounding villages. Contact me here, call 07763 100 477, or email hello@ayleshamhedges.co.uk.

Sources: RHS, "How to trim a hedge" (rhs.org.uk/videos/advice/Cutting-Hedges, RHS YouTube-hosted video guide, Royal Horticultural Society, UK); RHS, pruning guide for Leyland cypress and Lawson cypress (rhs.org.uk/plants/leylandii/pruning-guide, which applies the same method to Chamaecyparis lawsoniana); Garden Ninja (Lee Burkhill, UK garden designer), "My Conifer Is Too Big: What You Can Actually Do About It" (gardenninja.co.uk); Wildlife and Countryside Act 1981, section 1 (legislation.gov.uk).